ClassicBond Contact Adhesive 2.5Ltr
Use this adhesive with ClassicBond Rubber
Required for the edges of the EPDM Sheet when used on timber deck or onto the whole deck for other decks such as tissue faced insulation
Coverage: 0.5 Ltr / m2 when applied to both sides
This is a high strength, solvent based bonding adhesive specifically designed and manufactured to withstand the temperature extremes of flat roofing installations. Perfect for bonding ClassicBond the roof deck and vertical surfaces.
Required for the edges of the EPDM Sheet when used on timber deck with waterbased adhesive in the center or onto the whole deck for other decks such as tissue faced isnulation
Suitable for a range of surfaces e.g. timber, brickwork, metal, PVC & concrete.
Up-stands: Use a 4" mini roller to apply contact adhesive to both the up-stand and rubber roofing membrane. It is also good practice to secure the membrane to the deck perimeter with a 150mm width strip of contact adhesive. This will stop the membrane from lifting due to shrinkage.
Ensure that the contact adhesive is touch dry before rolling the membrane onto the substrate/up-stand.
Application Non-Permeable Deck:
Using a roller apply contact adhesive to both the deck and underside of membrane evenly. Ensure that the contact adhesive is touch dry before rolling the membrane onto the deck approx 5-20 minutes.
Note It is not possible to re-position the membrane once stuck down using contact adhesive.
- Size: 1.0 Litres (Coverage 1 to 2 sqm)
- Size: 2.5 Litres (Coverage 4 to 5 sqm)
- Size: 5.0 Litres (Coverage 7 to 10 sqm)
- Size: 10 Litres (Coverage 15 to 20 sqm)
- Coverage: 0.5 Ltr / m2 when applied to both sides (depending on surfaces)
- Glue Type
- Contact Adhesive
- 4 - 5sq.m
You might also like