Ex Vat Inc Vat

Flexitec 2020 Primer 2.5kg

£51.88 Ex Vat £62.26 Inc Vat
VAT excluded

Flexitec 2020 Primer is Used to Prime roof surface prior to application Resin

Available in 2.5kg & 5kg tins

Coverage dependant on Substrate Refer to Chart

Medium Felt = 0.29kg/sqm (2.5kg = 8.5sqm)

Same day dispatch if ordered before 12pm

100% secure payments

Flexitec 2020 Primer is recommended for all porous, bituminous, cementitious, timber and PVC single ply substrates. IMPORTANT - Failure to prime porous surfaces, such as concrete, brickwork, tissue-faced insulation or plywood may result in an under-cure of the Flexitec 2020 resin and potential system failure.

GRP surfaces, including ResTrims, do not require priming. Application Conditions Flexitec 2020 Primer should be applied in dry conditions between 5°C and 30°C ambient air temperature. Do not begin if conditions could fall outside of the temperature range and/or if rain appears likely.

Flexitec 2020 Primer is applied at a coverage rate of 3.5 to 5.3m2/kg depending on surface roughness. Rough or highly porous surfaces will significantly reduce the coverage rate. All coverage rates are indicative only and it is your responsibility to ascertain the exact coverage rates on site.

IMPORTANT – A recommended additional 10% wastage should be factored into the figures below.

The Flexitec 2020 System by Res-Tec is a flexible, single resin GRP system with full overlay and new deck capabilities. Combining the best elements of fibreglass with the versatility of overlay systems, no other flat roof solution performs at this level across so many applications.


Data sheet

Guarantee Length
Upto 20 Years

You might also like